Daily maintenance of spunbond non-woven equipment

Spunbond non-woven equipment can not make too much water and oil into the pressure system, in order to avoid breakdown, shorten the service life of the cylinder barrel, to ensure that the air dry and clean, if possible to check that the oil amount of each inner cup of the converter is enough, the pressure relief valve is not used for a long time at the back end, should be pushed, when stop working, should be turned off the power switch, compressed air control valve, The cylinder and all parts shall avoid magnetic loss. Assembly table side sliding seat parts and precision highly complex, often wipe clean, and oil maintenance, in order to prevent rust accuracy. Should pay attention to the environment and machine maintenance, workshop environment to clean, need to clean up before work, voltage, power detection, should ensure that the voltage in its use, to avoid the voltage is too high or too low, do not use contaminated hands to touch.

In addition to the above in the maintenance of non-woven equipment there are other methods of operation, but because of time problem, we will not tell more, you can check more relevant information on website. For the spunbond non-woven equipment, the correct maintenance is very important, which has a great impact on the service life and function of the machine. I hope that the tips we introduce can arouse everyone's attention.